MSB Technology DVD Audio Player Manuel d'utilisateur Page 5

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 41
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 4
5
Simple Setup and Quick Start
Location - This unit produces a lot of heat. DO NOT STACK, Do
not place anything on top of this unit or put in closed cabinet!
Power - The SDVDA Player comes standard with an inboard
power supply. A fuse block inside the unit allows the unit to be
switched between 240V and 120V. Please check the back of the
unit before plugging the unit in. Unit is configured for 120V
unless otherwise marked. Leave the SDVDA powered on all the
time.
Connections - Connect the video outputs and audio outputs using
the row of 8 RCA connectors. Be sure to connect to the set
labeled output, not the set labeled input!
Very Important - Be sure the toggle switch on the back of the unit
is set to AUTO (the center position).
Best Installation - Connect this player
directly to your Amplifiers and Monitor
or Projector. It is a complete system. If
you already have a system, connect it to
the inputs of this player. Connect the line
level audio from your system to the 6 or 8 AUDIO INPUTS. Insert
new cables from AUDIO OUTPUTS to your AMPS. Connect
the video connections from your system to VIDEO INPUTS.
Insert new cables from VIDEO OUTPUTS to Projector or monitor.
To use the SDVDA Player - Insert disc and play. Adjust volume
with either remote. (Volume starts out low on power up)
To use your existing system - Turn SDVDA Player off using
remote. (Leave unit plugged in). Adjust system volume with
either remote. Leave existing system volume at line level (0db).
Super DVD Audio Player
with Master Volume Controls and
Trims
Existing
System
AMPs
Audio
Out
Video
Out
Audio
In
Video
In
Display
Vue de la page 4
1 2 3 4 5 6 7 8 9 10 ... 40 41

Commentaires sur ces manuels

Pas de commentaire